Timecoding Digibeta Tapes

Using videotapes that have been blacked and timecoded will make your life much easier. Laying down an uninterrupted black video signal prepares the tape for insert editing. See the Editing Video Tapes page for more details on insert editing, assemble editing, and timecode.

Timecode format is hour:minute:second:frame. Minutes and seconds range from 0-60 while frames range form 0-30.

  1. Route black to the digibeta through a transcoder (FS1 or FS2).

  2. Set the TC Generator EXT/INT switch to INT (top panel on right, pull whole front out by handles to access)

  3. Set the TC Generator REGEN/PRESET switch: PRESET (next to above)

  4. Set VITC switch to ON (bottom underneath panel, tilt front panel out to access)

  5. In order to set the time code to 00:00:00, use the following buttons below the counter display on the front panel:

    1. Press the TC button - indicator lights

    2. Press the HOLD button - digits flash

    3. Press the RESET button then the SET button

  6. Press the assemble edit button (front panel, upper left)

  7. Press the red Auto-Edit button (front panel, lower left)

  8. I highly recommend that you let it run all the way to the end of the tape unless you're desperately pressed for time.

Return to Main Video Menu
videolab@graphics.stanford.edu
Last modified: Thu Jan 14 16:24:14 PST 1999